Structurally, the training laboratory equipment consists of a body frame with mounted electronic cards in, safety and relay units, front panel.
On the front panel are placed:
- driver seat airbag;
- seatbelt with belt tensioner;
- faults input unit;
- structurally circuit of placement the general safety system components of the vehicle.
The airbag is filled with the use of an air compressor controlled from the panel. The belt tightener has a rotator which allows observing the tightener operation from various planes. There is a schematic diagram depicting the location of the basic security elements in the central part of the panel. The security system operating mode is indicated by LEDs.
The stand implies the security system operation with different types of shock – frontal, diagonal, lateral. The security system operation can be observed in accordance with a special algorithm by means of the LEDs.
A system of fault introduction allows studying the security system operation when the following faults occur:
- shock sensor open circuit;
- driver airbag fault;
- passenger airbag fault.
- shock sensor short circuit.
The training system is supplied with a set of methodical and technical documentation for teaching staff.