The bench is a welded frame with an electric lift on it. A force sensor with a measuring limit of 5000N is installed on the lift. Removable tools for conducting labs are screwed at the upper thread of the sensor. The lift control is performed by a wired remote control.

For conducting labs it is necessary to prepare the bench by installing samples in the target area (install the necessary hasp) and connect it to measuring system if necessary.

The training system is accompanied with:

software;
a set of teaching materials and technical documentation intended for the teaching staff.

Experiments provided

Elastic modulus and Poisson’s ratio: experimental determination.
Shear test.
Pure bending: verification of the normal stress distribution law.
Beam bending: definition of linear and angular displacements of cross sections.
The combined action of bending and torsion of thin-walled rod: determination of the shear modulus.
Determination of the principal stresses.
Compression the bar of great flexibility: the definition of critical force.

Technical specifications

Power supply		~50Hz 220V (single-phase 220V 50Hz)
Bench overall dimensions, max
	Width, mm	400
	Height, mm	1100
	Depth, mm	600
Deformation meter overall dimensions, max
	Width, mm	300
	Height, mm	100
	Depth, mm	220
Weight, kg, max		150

Scope of delivery

training laboratory system – 1 pc.;
set of accessories for experiments – 1 set;
samples for test – 1 set;
digital deformation meter – 1 pc.;
passport – 1 pc.;
supplementary materials in electronic format – 1 pc.

Additional equipment (specified when ordering)

Necessary additional equipment:

PC or laptop

NTC-13.06.2 “Strength of materials M1”

Experiments provided

Technical specifications

Scope of delivery

Additional equipment (specified when ordering)

Necessary additional equipment:

Login