NTC-09.08.2 “Winch drive”

Br0.00

The present training laboratory equipment is intended for using it at secondary specialized colleges and higher education establishments for performing laboratory classes.

The equipment is dedicated for studying general methods of installation, diagnostic and setting up the winch drive.

*For additional information, you can contact us via the phone numbers or email provided on the website.

Structurally, it consists of:

Actual model of elevator winch;
Control unit.

Stand allows to:

study linear winch speed dependence on supply voltage frequency;
timing the acceleration and deceleration according to the recommended values;
exact stop setting depending on the selected speed;
typical faults simulation arising at winch drive operation and to study reply signals of the equipment.

The training laboratory equipment is accompanied with:

a set of teaching materials and technical documentation intended for the teaching staff;
software.

Technical specifications

Power supply		~50 Hz, 220 V
Consumed power, kW, not more than		2.0
Overall dimensions of elevator winch model, not more than
	width, mm	1460
	height, mm	1500
	depth, mm	680
Overall dimensions of control unit, not more than
	width, mm	1310
	height, mm	1400
	depth, mm	600
Weight of elevator winch model, kg, not more than		500
Weight of the control unit, kg, not more than		33

Scope of delivery

training laboratory equipment – 1 pc.;
USB-cable – 1 pc.;
multimeter – 1 pc.;
set of jumpers and connecting cables – 1 set.;
passport – 1 pc.;
supplementary materials in electronic format – 1 pc.

Additional equipment (specified when ordering)

Necessary additional equipment:

PC or laptop

NTC-09.08.2 “Winch drive”

Technical specifications

Scope of delivery

Additional equipment (specified when ordering)

Necessary additional equipment:

Login